UniFi Protect SuperLink Glass Break Sensor 1.3.3 includes the improvements and bugfixes below.

Improvements

• Added a 1-minute timeout for LED patterns.
• Improved the low battery LED pattern by changing it from continuous illumination to three blinks.

Bugfixes

• Fixed an issue where tamper detection did not work unless the motion detection channel was enabled.
• Fixed an issue where Glassbreak events could be triggered during a sound test even when detection was disabled.
• Fixed an issue where a latched tamper event could occur after adoption by disabling tamper detection until the device is adopted.

UniFi Protect SuperLink Glass Break Sensor 1.2.1 includes the improvements below.

Improvements

• Improved battery wear calculation.
• Improved device stability.

This is the initial release for the USL-GlassBreak.